ASTM E428 PDF

ASTM Distance-Amplitude #3, #5, #8 FBH Blocks (set of. 19). 9. EDM Notches . amplitude. Specifications: ASTM E, ASTM. E Calibration. Application. This standard is issued under the fixed designation E ; the number immediately following the The method most widely accepted by ASTM has been. Find the most up-to-date version of E at Engineering

Author: Mozilkree Dum
Country: Samoa
Language: English (Spanish)
Genre: Science
Published (Last): 18 December 2015
Pages: 67
PDF File Size: 17.97 Mb
ePub File Size: 5.28 Mb
ISBN: 112-9-39550-755-1
Downloads: 61911
Price: Free* [*Free Regsitration Required]
Uploader: Tojarr

This practice shall in no way preclude the specification or addition of any supplemented requirements as deemed necessary for the specific application. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine f428 applicability of regulatory limitations prior to use. Also see Reference 2 for cautions regarding use of standard blocks for test standardizations.

ASTM E – 00_百度文库

The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Link to Active This link will always route to the current Active version of the standard. Note 1 — Use of flat-surface reference blocks may not be suitable for cylindrical materials 3 2. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Most Related  LUJZA HEJ PDF

This practice, however, must not be confused with, nor does it supersede Practice Especifically governing the fabrication and evaluation of T6 aluminum alloy ultrasonic standard reference blocks. The values given in parentheses are mathematical conversions to SI units that are provided for information e4288 and are not considered standard.

Active view current version of standard. Additional procedures and controls may be required when fabricating reference blocks from other than carbon asm alloy steel material. Unlike this practice, Practice E has requirements for evaluation relative to a specified standard target. See Reference 1 for area-amplitude limitations at other frequencies and transducer diameters.

Active view current version of standard Translated Standard: Note 2 — Practice E and Guide E also describe procedures for selecting material, fabricating blocks, and checking response.

The reference blocks described are suitable for use with either the direct-contact method or immersion pulse-echo ultrasonic methods. The reference blocks described are suitable for use with either the direct-contact method or immersion pulse-echo ultrasonic methods.

This practice shall in no way preclude the specification or ast, of any supplemented requirements as deemed necessary for the specific application. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Most Related  ANSI A117 1992 PDF

Additional procedures and controls may be required when fabricating reference blocks from other than carbon or alloy steel material. Link to Active This link will always route to the current Active 4e28 of the standard.

Asstm practice, however, must not be confused with, nor does it supersede Practice Especifically governing the fabrication and evaluation of T6 aluminum alloy ultrasonic standard reference blocks. Historical Version s – view previous versions of standard.

Note 2—Practice E and Guide E also describe procedures for selecting material, fabricating blocks, and checking response. Comparison test at other e248 or with uncalibrated instruments will not necessarily give the same relationships shown in this practice.

Note 1—Use of flat-surface reference blocks may not be suitable for cylindrical materials 3. Unlike this practice, Practice E has requirements for evaluation relative to a specified standard target.